Toggler TB Hollow-Wall Anchor for 9–13mm Panels

The Toggler TB is a versatile wall anchor designed for fixing into compatible hollow-wall panels approximately 9–13mm thick. Its anti-rotation design helps prevent spinning while the screw is installed, providing a secure fixing point for suitable wall-mounted fixtures.

The TB is intended for a thicker panel range than the Toggler TA. Always measure the wall material before choosing the anchor model and confirm the required screw size and installation-hole diameter from verified manufacturer information.

Key benefits

• For 9–13mm hollow-wall panels: designed for compatible boards within this thickness range.
• Anti-rotation design: helps resist spinning as the screw is driven.
• Vibration-resistant fixing action: designed to maintain its hold under normal installed conditions.
• Simple product selection: the model is identified by its intended panel-thickness range.
• Removable screw: the screw can be removed where the anchor and substrate remain sound.
• Versatile application: suitable for compatible hollow walls and certain solid materials where permitted.

Typical applications

• Hollow-wall panels approximately 9–13mm thick
• Suitable plasterboard, drywall and sheet materials
• Wall-mounted accessories and lightweight fittings
• Small brackets, clips and electrical accessories
• Maintenance and refurbishment work

Suitability and safe loading depend on the exact wall material, panel thickness, substrate condition, fixing spacing, screw engagement, fixture and loading direction. Do not publish a universal load figure without verified technical information for the exact installation.

Technical specifications

Installation guidance

1. Confirm that the panel material and thickness are suitable for the TB anchor.
2. Check for concealed pipes and electrical cables.
3. Mark the required fixing position.
4. Create the manufacturer-specified installation hole using the correct tool and an approximately 8mm diameter.
5. Insert the anchor until its flange sits against the wall surface.
6. Position the fixture and insert a compatible 4.0mm or 5.0mm screw.
7. Tighten until the fixing is secure without overtightening or damaging the panel.

The exact installation-hole diameter and screw range above are based on the current TB product record. Do not copy measurements from the TA or another Toggler anchor.

Frequently asked questions

What panel thickness is the TB anchor designed for?

The TB is designed for compatible hollow-wall panels approximately 9–13mm thick.

What is the difference between TA and TB?

The TA is intended for thin panels approximately 3–6mm thick. The TB is intended for thicker panels approximately 9–13mm thick. Select the model that matches the measured wall thickness.

Can the TB be used in plasterboard?

It can be used only where the plasterboard type, thickness and condition fall within the manufacturer’s requirements. Measure the board and verify suitability before installation.

What screw size should be used?

The current TB product record specifies compatible 4.0mm and 5.0mm screw diameters. Confirm the required screw length for the fixture and engagement.

Can the screw be removed?

The screw can be removed where the correctly installed anchor and surrounding wall material remain sound. Inspect the fixing before reuse.

Can the TB be used in solid walls?

The anchor may work in certain suitable solid materials, but the substrate and installation method must be checked against verified manufacturer guidance.

Is a screw included?

The current product record does not confirm that a screw is included. Check the packaging for the exact pack contents; if no screw is supplied, a compatible screw is required separately.

How much weight can the TB support?

The safe working load depends on the panel material, thickness, condition, screw, installation quality, fixing spacing and fixture. Use verified technical data for the exact application.

Related hollow-wall fixings

• Toggler TA hollow-wall anchor for 3–6mm panels
• Toggler TC hollow-wall anchor for 16–20mm panels